High-performance automatic pressure forming machine RDK 90

Technical data

Thermoforming machine - Basic version
Forming area for forming/punching operation	max.	827 x 657	mm
Forming area for forming operation with actuated clamping frame	max.	840 x 670	mm
Tool width between material transport with actuated clamping frame	max./min.	870 / 500	mm
Tool width between material transport without/with actuated clamping frame	max./min.	870 / 500	mm
Tool length in operating direction	max./min.	750 / 350	mm
Material width with actuated clamping frame	max./min.	900 / 550	mm
Material width machine discharge side	max.	950	mm
Spreading dimension per side	max.	25	mm
Material thickness subject to material type	max.	2.5	mm
Material thickness	min.	0.2	mm
Accuracy of material transport (measured on intermediate bridge of skeletal)		+- 0.2	mm
Index length	max./min.	700 / 330	mm
Height of formed part above material level	max.	160	mm
Height of formed part below material level	max.	160	mm
Height of total formed part	max.	160	mm
Table stroke on top	max.	180	mm
Table stroke on bottom	max.	180	mm
Stroke of clamping frame on top	max.	180	mm
Stroke of clamping frame on bottom	max.	180	mm
Servo-drive of pre-stretcher	max.	180	mm
Heater length upper heater		2800	mm
Heater length lower heater		2800	mm
Conveying capacity of vacuum pumps	max.	200	m³/h
Forming pressure		6	bar
Number of cycles, only forming	max.	55	/min
Number of cycles, forming and punching	max.	55	/min

Application search